Yellow epoxy height measuring rod

Orange phenolic height measuring rod

Note: The above parameters are for reference only, and the actual parameters are subject to the actual object.

Manufacturing process of height measuring rod

The high-pressure height measuring rod is made of epoxy resin, which greatly enhances the bending capacity, fine process, light structure and convenient operation.
Accurate positioning, clear surface scale, with excellent mechanical and electrical properties,
It has the advantages of light weight, high strength, good pressure resistance, precise scale, etc,
Suitable for a variety of high pressure conditions under the conditions of the use of height measurement places, the measurement error is not greater than 5cm

Height measuring rod instructions for use

When using the height measuring rod, open the rod cap, tighten the hook on the screw of the 1 section, and then pull it out section by section to the joint of the two sections. You can use a little force and pull it out while screwing to align the vertical lines of the two sections of the scale until the semicircle mark between the two sections is rounded, and then confirm whether the pin pops out.
2.
When retracting the rod after using the height measuring rod, hold the thick 1 section of the bottom handle with your left hand, hold the pin down with your thumb and hold the thin 1 section on the top with your right hand, push back while twisting, loosen the joint of the two sections in turn, and retract section by section.

The height measuring rod unscrews the hook and install the electroscope head, which can be used as the electroscope rod.

Note

1.The height measuring pole shall be used vertically, if the pole is pulled out, erected or laid down with excessive force or Improper use may cause rod fracture

2. When the is loosened, do not use too much force, otherwise the product will be damaged or the hand will be injured.
Danger.
3.Keep the rod body dry when the is charged with height measuring rod.